Function for conversion of video signals
The receiver is equipped with a function for converting video signals.
Video signals and component video signals can be output as HDMI video signals (*1).
The correspondence of the INPUT jacks to the OUTPUT jacks is shown below.
- HDMI IN: HDMI OUT
- COMPONENT VIDEO IN (for STR-DN1050 only): HDMI OUT (*1), COMPONENT VIDEO MONITOR OUT (*2)
- VIDEO IN: HDMI OUT (*1), MONITOR OUT (*2)
*1 For STR-DN1050 only. Video signals are upconverted when output (up to 4K).
*2 The same type of signal as the input signal is output.
Note
- When video signals from a VCR, etc., are upconverted on this receiver and then viewed on your TV, the image on the TV screen may appear distorted horizontally or no image may be seen depending on the status of the video signal output.
- If you are using image improvement circuitry with your VCR, it may impact the video signal conversion. It is recommended that you turn off this function on your VCR.
- Converted HDMI image output does not support “x.v.Color (x.v.Colour),” Deep Color (Deep Colour), or 3D.
- HDMI video signals cannot be converted to component video signals or video signals.
- 1080p component video signals cannot be upconverted.
- When [4K Scaling] is set to [Auto], if the HDMI input signals are [email protected]/24 Hz and a 4K-compatible TV is connected, the HDMI input signals are automatically upscaled to 4K images and output from the HDMI OUT jack.