Location of controls (Portable Ultra Short Throw Projector)

The location of controls of the projector is described below.

  1. Ventilation holes (intake/exhaust)
  2. Projection window

    Projects images onto a wall, table or floor.

  3. Remote control receiver

    Receives signals from the NOT TRANSLATEDHDMI device’s remote control to transfer the signals to the NOT TRANSLATEDHDMI device connected to the Wireless Unit, thus allowing you to operate the NOT TRANSLATEDHDMI device. The Wireless Unit and the NOT TRANSLATEDHDMI device should be connected via the IR Blaster (supplied).

  4. Speakers
  5. Power indicator

    Indicates the status of the power and battery of the projector.

  6. Power button

    DELIMITER [NOT EC]
    Press and hold to turn the projector on/off. Press lightly while the projector is turned on to switch between standby/power-on.
    DELIMITER [NOT EC]
    DELIMITER [EC]
    Press and hold to turn the projector on/off. Press lightly while the projector is turned on to switch between networked standby/power-on.
    DELIMITER [EC]

  7. Illumination sensor

    Measures the ambient illumination to adjust the projection screen brightness.

  8. NOT TRANSLATEDDC IN 19.5V jack

    Connect the AC adaptor NOT TRANSLATEDVGP-AC19V77 (supplied).

  9. Distance sensor

    Measures the distance between the projector and the projection surface.

  10. NOT TRANSLATEDRESET button

    Resets and restarts the projector.

  11. Charge indicator

    Turns on during charging.

  12. Power jack for the stand (sold separately)

    Supplies power to the floor stand (sold separately) when the projector is mounted on the stand.

Go to Page Top